Follow Asunpower on Twitter
Join our mailing list!

  Home > CHARGE CONTROLLERS >

  Solartech Power 12 Volt 5 Amp Charge Controller
  Solartech Power 12 Volt 5 Amp Charge Controller


 
Price: $29.99


Availability:: Usually Ships in 24 to 48 Hours
Product Code: CHG-60S

Description
 

MODEL NUMBER: CHG-60S (DISCONTINUED)
Features
  • Automatic Sequencing Charger 12 Volt 5 Amps






    Full Charging: Ensures that the batteries are always topped off.

    Reduced Maintenance: from healthy charging and reliable operation.

    High Voltage Shut-off: Shuts off only when battery is full.

    Simple, rugged electronics: low component count and streamlined design ensure long term reliability.

    Maximum environmental protection:Ideal for outdoor mounting

    Terminal Block: for sound and easy wire connections.




    INSTALLATION INSTRUCTIONS:

    The Charge Controller may be mounted in almost any indoor or outdoor
    location. The unit should be mounted as close as possible to the
    batteries to avoid errors in battery voltage reading. The Charge
     Controller may be mounted on the rear of the solar panels using
    outdoor-type double-stick foam tape. On units with temperature
    compensation (Option-A), the Charge Controller should be mounted within
    10 feet (3m) of the batteries to enable the sensor cable to reach the
    battery.




    PROTECTION REQUIREMENTS:

    The circuitry of the Charge Controller is encased within hard epoxy
    resin that offers substantial protection from the environment.


    The unit should not be mounted in direct sunlight or close to any heat
    generating source to avoid extreme temperature increases. The rear of
    the unit should not be blocked to allow air flow for adequate cooling.

    The exposed terminal block is made of corrosion resistant nickel plated
    brass. This will endure most outdoor environments. When the Charge
    Controller is in an excessively corrosive location, a coating of an
    oxide inhibitor should be applied to the terminals.


    The optional sensor and cable need to be protected from damage (cuts,
    impacts, rodents). If the sensor or cable is damaged, the Charge
    Controller will not operate. (Refer to Options section: OPTION - A)


    When possible, use stranded wire rather than solid wire. Stranded wire
    is less likely to fail and cause loose connections over time. Consider
    using wires of different colors to indicate source or polarity. Also,
    select a wire that offers the appropriate insulation for the condition
    of the location. (Refer to the U.S. National Electrical Code)

    Select wire of sufficient gauge to safely handle the rated current of
    the system and to limit voltage drop. The Charge Controller terminals
    accept up to 10 gauge stranded bare wire (and 12 gauge solid wire).
    (When using 10 gauge stranded wire, divide the end wires into two equal
    sections and straddle the terminal screw). An alternative to using
    larger wire is to use two wires in parallel for each connection.


    WARNINGS

    Electricity, even low voltage electricity, can be dangerous.
    Installation should be performed by a licensed electrical contractor or
    other qualified personnel only. The requirements of the U.S. National
    Electrical Code should be followed.

    Follow all safety precautions of the battery manufacturer. Proper
    ventilation must be provided for the batteries. Most batteries produce
    hydrogen gas when charging, which is extremely explosive. Provide
    adequate battery ventilation. DO NOT expose the battery to open flame,
    matches, cigarettes or sparks.

Related Products...
ASC 12/16 Charge Controller, 16 amps, 12
Price: $53.95
Add
Specialty Concepts Charge Controller, 16 amps, 12 volts ASC 12/16
Morningstar SunGuard SG-4, PWM Single Module Controller
Price: $29.99
Add
Morningstar ProStar PWM Charge Controller, 30 Amp,
Price: $189.99
Add
Morningstar ProStar PWM Charge Controller, 30 Amp, 12 Volt, Digital Meter
Morningstar Sunsaver 12 Volt 10 Amp Charge Controller/ LVD Override Protection
Price: $59.99
Add
Morningstar Sunsaver 12 Volt 6.5 Amp Charge Contro
Price: $43.99
Add
Morningstar Sunsaver 12 Volt 6.5 Amp Charge Controller
Share your knowledge of this product with other customers... Be the first to write a review

Browse for more products in the same category as this item:

CHARGE CONTROLLERS


Solartechpower 85 Watt 12 Volt Multicrystalline Solar Panel $350.00
Solartechpower 65 Watt 12 Volt Multicrystalline Solar Panel $219.99
Solartechpower 55 Watt 12 Volt Multicrystalline Solar Panel $199.99
Solartechpower 210 Watt 12 Volt Multicrystalline Solar Panel $550.00
15 FT Long MC4 Style Cable $39.99
30 FT Long MC4 Style Cable $59.99
Morningstar Sunsaver 12 Volt 10 Amp Charge Controller/ LVD Override Protection $59.99
Morningstar Sunsaver 24 Volt 10 Amp Charge Controller/ LVD Override Protection $69.99
Morningstar SunGuard SG-4, PWM Single Module Controller $29.99